Can some one check this file please.

[ukracer]

I was super happy as I managed to sit down and design a file almost without relearning what I already knew. Sadly I think I messed up somewhere along the line. I think its possibly not sitting on the bed correctly as I have had three failures now and I never get bed adhesion problems since getting the Bambu and Pei plate. The fact its right rear coming adrift all three times makes me think its not sitting flat. BUT I used layflat to bed in Bambu studio so I cant see why its not sitting flat if it is indeed whats causing my problems.

Dropbox

www.dropbox.com

 

[Screwdriver]

Lay it on its side so that the knobs point up. Currently they point to the right and are floating though I am not sure if you're even getting that far into the print...

 

[ukracer]

Lay it on its side so that the knobs point up. Currently they point to the right and are floating though I am not sure if you're even getting that far into the print...

I must have linked the wrong file. I have turned it round and that's where it started to go wrong.

I have sorted it now though thanks...more handy less speed. I was printing whilst cooking so I never watched the 1st layer go down. I assumed it was fine as Bambu never complained. Lol

When I watched it I saw it was raised a mm or 2 of the bed at the RH end. So I started again and re exported from fusion and was more careful rotating it.
The lay flat to bed in Bambu was useless.....

Anyway I am.now printing one I have extended by 3mm (whilst I go and sort my dad's legs out)

Should be ready to test when I get home.