henry Kadzielski
Member
- Messages
- 1,169
- Location
- Australia Wollongong
Good morning gents. Just completed the scriber calibrations and checking the 'squareness' of the machine. All looked good after adjustments and cut the first 3mm sheet as a test. No photos or vid as was busy looking and checking stuff but found the parts .5mm to .75mm oversize after putting a tape over them. Parts were 2mm long and 1mm wide approx. So it seems a small adjustment to the kerf compensation and we are good to go. Will upload a vid of the first cut from a sales rep that was here to watch and took the vid. Hope it comes out OK.