Bolts you will need.

[CRB]

?How many times have you needed at least one of these.

 

[hunter27]

?How many times have you needed at least one of these.
View attachment 65523

Brilliant can you get them in 316 Stainless ?

 

[mike os]

I know someone who could do with a complete set, are they available in imperial and metric?

 

[mechman]

I know someone who could do with a complete set, are they available in imperial and metric?

The only sizes they come in are 10degrees centemetres

 

[wristpin]

?How many times have you needed at least one of these.
View attachment 65523

Seen it before on paper but never in the metal - wonderful!

 

[Kent]

Err,
Never !

 

[whm_fab]

the second one would actually be handy sometimes!

 

[steve t]

I could use the vice grip ones all the time

 

[mike os]

The only sizes they come in are 10degrees centemetres

damn... I need some in pound decibel lumens

 

[mike 109444]

Do they come with matching nuts (hope there not dry roasted, prefer salted)

 

[stormin]

I remember on a steelwork job years ago the holding down bolts had been set-out incorrectly and mostly too low. We had to draw up a set of custom, extended nuts and offset nuts to accomodate for each base plate. Some base paltes had to be cut-off and amended with different hole patterns.

 

[Shox Dr]

The guy that supplies the portal frame buildings, I have the misfortune of erecting from time time, must use the drill set for those

 

[rikrobson]

Err hang on a minute. Where is the curved one for going round corners

 

[mike 109444]

And the cross threaded ones that saves you having to do it yourself.

 

[rikrobson]

And the snapped ones and the rusted up ones too

 

[tomsutton529]

Could have done with some of those when fitting a mill today.

 

[Undergroundmike]

Hahhaaaaa quality

 

[Undergroundmike]

I can tell I'm going to like this place!

 

[mike os]

Have they got one for going into striped holes? ... need one for a 3 jaw chuck just rebuilt the ÷×###@ thing too