Johannes
New Member
- Messages
- 1
- Location
- Australia NSW
Not certain if this is the correct forum but here it goes.
I am after certain bolts that I can use as a shaft for none load carrying pulleys.
These are the same pulley used in laser printers.
I was thinking Metric Shoulder Bolts like the one pictured below?
The bolt length is not too critical but the dia is.
The pulley bore inner dia is 5mm and 6mm, two different pulleys.
One pulley is 9mm wide (partially 9mm none threaded) x 5mm bore DIA.
The total shoulder bolt length minimum should be about 15mm to fit on a metal frame with a nut.
The other pulley is 16mm wide (bore length) x 6mm bore DIA
This should be 16mm none threaded and a total length of around 25mm to include the last 8mm threaded so I can mount this on a frame with a matching nut.
I am going to attach a couple of pics as a means of further explaining what I am looking for
Any input is appreciated as I am a bit of a novice at this.
What I am trying to do is adapting a existing camera slider to add a DC motor driven with a flat belt along a rail. This is where a need the bearing roller pulley's that need the be mounted on the slider frame to guide the belt. Hope this helps with any ideas.
I am after certain bolts that I can use as a shaft for none load carrying pulleys.
These are the same pulley used in laser printers.
I was thinking Metric Shoulder Bolts like the one pictured below?
The bolt length is not too critical but the dia is.
The pulley bore inner dia is 5mm and 6mm, two different pulleys.
One pulley is 9mm wide (partially 9mm none threaded) x 5mm bore DIA.
The total shoulder bolt length minimum should be about 15mm to fit on a metal frame with a nut.
The other pulley is 16mm wide (bore length) x 6mm bore DIA
This should be 16mm none threaded and a total length of around 25mm to include the last 8mm threaded so I can mount this on a frame with a matching nut.
I am going to attach a couple of pics as a means of further explaining what I am looking for
Any input is appreciated as I am a bit of a novice at this.
What I am trying to do is adapting a existing camera slider to add a DC motor driven with a flat belt along a rail. This is where a need the bearing roller pulley's that need the be mounted on the slider frame to guide the belt. Hope this helps with any ideas.
