BOC ADR 300 foot control problems

[lotus 30]

The welder is working on tig but i have no response to the foot control it runs at the min set on the main amps switch the remote switch is set to remote.
If i switch it to local the rheostat will work and the amps increase as i adjust it. plus it it warming up
I have checked the foot control and all looks to be fine.
I have a spare foot control so changed it and it is the same i still cannot control the amps with the foot control any ideas please.
I am going back out to check the amps plug on the machine be back later.
andy

 

[gordon stephenson]

Some sets need the foot pedal only plugged in, Any other plugs must be removed first.

 

[lotus 30]

Fixed it read everything on the forum and carried out the test's Dave crackett suggest and it was the soft start switch one of the copper contacts had got warm and was no longer in the correct place when switched sorted that and it all works full control with the foot peddle chuffed
andy

 

[NotANormalCoder]

I was just about to reply with comments regarding the soft start switch - As I scrolled down, I saw that you already fixed it using info I previously posted.
Good to know that folk do some research and that I have been of some help.
Dave

 

[lotus 30]

I was just about to reply with comments regarding the soft start switch - As I scrolled down, I saw that you already fixed it using info I previously posted.
Good to know that folk do some research and that I have been of some help.
Dave

Dave some help is an understatement i could not have done it without your expertise thank you.
andy