simple questions to some but if dont ask.
anyway im going to make a woodburninh heater (just like everybody else on the forum from an old calor gas bottle)
the handles been cut of and the valves out, the bottles venting upside down in the garden, most peaple seem to advacote a week venting and filling with water for a bit.
will a jigsaw be able to cut these bottles or is there a better way to cut the holes for the air vents, say 2inch diameter and the hole for the flue, say 4inch
what have peaple made the flue from?
can/how do you weld stainless to mild steel?
anyway im going to make a woodburninh heater (just like everybody else on the forum from an old calor gas bottle)
the handles been cut of and the valves out, the bottles venting upside down in the garden, most peaple seem to advacote a week venting and filling with water for a bit.
will a jigsaw be able to cut these bottles or is there a better way to cut the holes for the air vents, say 2inch diameter and the hole for the flue, say 4inch
what have peaple made the flue from?
can/how do you weld stainless to mild steel?
