steviec_lj
Rust Welding Professional
- Messages
- 2,806
- Location
- Barnetby, N.Lincs
Looking to build a roof tray/rack/pod on the L200, so carrying those extra bits and pieces.
Similar to this;
But a little more over engineered, and elaborate!
Plan is to use 40x20 RHS for the rack on top, and potentially 30mm CHS for the hoops.
Plans could obviously change, in fact they no doubt will.
How would one go about bending the RHS? 20mm width would be the top/bottom faces, with the 40mm being the upright faces.
I currently have a Clarke compact bender https://www.buildingsuppliesdirect....MI0If6rL3n7QIVEJntCh06Gwa9EAQYBCABEgLCsPD_BwE
Similar to this;
But a little more over engineered, and elaborate!
Plan is to use 40x20 RHS for the rack on top, and potentially 30mm CHS for the hoops.
Plans could obviously change, in fact they no doubt will.
How would one go about bending the RHS? 20mm width would be the top/bottom faces, with the 40mm being the upright faces.
I currently have a Clarke compact bender https://www.buildingsuppliesdirect....MI0If6rL3n7QIVEJntCh06Gwa9EAQYBCABEgLCsPD_BwE