Hi all
Any advice on bending some headers, I have an old set from a Honda S2000 that almost but dont quite fit an exhaust manifold plate for my Duratec 2.5.
Two middle pipes need to be shifted about 5mm towards outer pipes and would be perfect.
I can move them with leverage but they spring back, have tried some heat but no improvement.
I could cut them, rotate a bit and reweld but not sure my welding skills are up to it.
Thx!
Any advice on bending some headers, I have an old set from a Honda S2000 that almost but dont quite fit an exhaust manifold plate for my Duratec 2.5.
Two middle pipes need to be shifted about 5mm towards outer pipes and would be perfect.
I can move them with leverage but they spring back, have tried some heat but no improvement.
I could cut them, rotate a bit and reweld but not sure my welding skills are up to it.
Thx!