Bambu Studio or Orca slicer

[ukracer]

I have a file with a simple draw rail but cant for the life of me work out how to measure between two points. Being the center of the pins that stick into two holes in the cupboard.

It would be great if you could record the process so I know how to do it in the future. I have tried shift left click but it gives me random results. I need the center of the two pins 160mm apart.



https://www.dropbox.com/scl/fi/d8c5...ey=0d57l7uokfwclvu784118xeu1&st=xzpginoi&dl=0

 

[Screwdriver]

162.22mm centres but the two pins are not on the centre line of the part and are offset from each other by 0.7mm.

 

[ukracer]

162.22mm centres but the two pins are not on the centre line of the part and are offset from each other by 0.7mm.

Mmm I thought i had got them close to 160mm.

I knew the pins were not level as I did not have time to check how to ensure they were central. I did it by eye.

I have been really struggling mentally and thought I had got through it but the file i thought I had solved ( not this one) failed again today.

I was told today some had said I run into their car. And while my memory is dire it's not that dire.

It's the small things like this file that hurt the most as I know it's simple. But till it's done the draws keep falling down. God knows why but still.

 

[knighty]

if you give dimensions of how you wasn't it I'm happy to make an stl for you so you can print it if that'll help? (happy to print too)

I fell on my head (badly) a few years back, really knocked me for six, it was horrible.

I don't have either of those programs so can't edit the file you have made or help with how to do it