gasket999
getting there...
- Messages
- 370
- Location
- Manchester, UK
Long shot - but does anyone have a PSBC990 (generic blast cabinet, made in China, with the pressure pot on the bottom)?
Specifically I’m looking for some photos and a couple of measurements from the original version of this cabinet - the one where the hose enters the cabinet up through the front right corner of the perforated tray, like this:
(On the later one, and the one currently stocked by suppliers, the hose enters through the top right corner of the back wall and there’s a few other changes that are slightly different on my older one).
Reason I ask is that I have an first-gen SBC990 that has been retro fitted with the pressure upgrade kit by the previous owner and there are a few mods to the steelwork/that I’d like to undo and redo to factory spec: hence needing the photos/measurements.
Thanks very much in advance.
Specifically I’m looking for some photos and a couple of measurements from the original version of this cabinet - the one where the hose enters the cabinet up through the front right corner of the perforated tray, like this:
(On the later one, and the one currently stocked by suppliers, the hose enters through the top right corner of the back wall and there’s a few other changes that are slightly different on my older one).
Reason I ask is that I have an first-gen SBC990 that has been retro fitted with the pressure upgrade kit by the previous owner and there are a few mods to the steelwork/that I’d like to undo and redo to factory spec: hence needing the photos/measurements.
Thanks very much in advance.
