Gragson
Member
- Messages
- 2,726
- Location
- Bucks
I've cut out a piece of 2mm thick brass to 50mm x 15mm to fit a pre cut notch in a stick which I will brass pin to.
I would like Gragson engraved or etched on it, I've no idea about fonts, but ideally nothing too modern or squarish.
Anyone on here got the gear for this for beer tokens?
I would like Gragson engraved or etched on it, I've no idea about fonts, but ideally nothing too modern or squarish.
Anyone on here got the gear for this for beer tokens?
