Any one can tell me what fitting is needed for this

[angellonewolf]

 

[awemawson]

A 19 mm spanner to remove it and fit a more standard PCL type fitting

 

[Wallace]

Comp-air by Broomwade comes to mind.

 

[500e]

Could be a PCL 5106 (expensive) originally Broomwade as Wallace said, comes in 2 sizes.
They are a secure fitting requiring both hands to remove.
Change as awemawson sugested, but think about flow rates as some flow a fair more air good for air hungry tools.

 

[angellonewolf]

sorry want this on the cheap so unless it cheaper to remove and replace than just buy a fitting

its for home and poss work i got a big ish air compresser in the garage but it tucked in to a corner and has to be pulled out and pluged in and when im doing repairs on mower/pit bikes/chain saws it a right pain to plug in the big one just to blow through once i have sonic cleaned the carb oh and move all the kids stuff out the way first im thinking welding a handle that can bolt on this so its easy to move around or its small enought to have it pluged in near the back door of the garage but im going to get murddered when i get home otherhalf has put her foot down and said no more tools

and to be fair i have got a big compresser already

i might leave it at work for a while and cough use it there untill they dont want it and then bring it home after they throw it out cough

 

[angellonewolf]

i plan on using a bit of garden hose for the hose

 

[angellonewolf]

Could be a PCL 5106 (expensive) originally Broomwade as Wallace said, comes in 2 sizes.
They are a secure fitting requiring both hands to remove.
Change as awemawson sugested, but think about flow rates as some flow a fair more air good for air hungry tools.

dont think this will be running any tools the tank is about a foot long and 6 inch high it only for compressed air for blowing out dirt and cleaning out water out of carbs i might get a mini paint sprayer if it can handle it seen a few posts on here a month or so ago for cheap from china that they say are quite good cant find the post now dont know if it will run it

 

[Cobbler]

Change it out for PCL XF Screwfix is the cheapest I know of, half the price of MMart

 

[angellonewolf]

is this just a standard size 1/4 bsp fitting thread ?

 

[angellonewolf]

thanks for the offer @pdg message in coming

 

[Windy Miller]

I think I have one of those if you still need it...

I 'found'it when I finished my apprenticeship in 1982, and I THINK it's still in my old toolbox...

 

[angellonewolf]

thanks for the offer @Windy Miller but with luck pdg is sorting me a few standard fittings what will make them inter changeable with my bigger unit at home so should be sorted

but again thanks