A couple of stainless plates needed please.

[ajlelectronics]

I will draw this up properly tomorrow, but this is my aide memoire sketch.

Thickness unimportant, I am thinking 1.6mm to keep it reasonably stiff. 300 x 90mm with four 6mm holes at 50 x 70mm. Holes start 40mm from one end. One large hole at the other end to take an SO239 socket, 17mm I believe. Corners to be radiused, 5mm maybe, just to take the point off?

Happy to pay the full going rate if someone could make them for me please?

 

[doubleboost]

Do a better drawing
I would be able to plasma cut that for you .

 

[ajlelectronics]

Do a better drawing
I would be able to plasma cut that for you .

That would be wonderful. I will draw it up in the morning.