The Artilleryman
Member
- Messages
- 449
- Location
- Boston UK
I've a couple of the above to make in sae660 bronze.
I was going to machine the hex to the same size as the major size of the thread, but came across some steel ones - possible hydraulic fitting - where the hex head is much larger than the major size.
Any thoughts? They have to be bronze as they are for a miniature traction engine boiler.
I was going to machine the hex to the same size as the major size of the thread, but came across some steel ones - possible hydraulic fitting - where the hex head is much larger than the major size.
Any thoughts? They have to be bronze as they are for a miniature traction engine boiler.