not done it yet
Member
- Messages
- 2,267
- Location
- Lincs/cambs/Rutland/Northants
Using calipers for inside measurement of small diameters is never too accurate. Likely better taking the OD and subtracting twice the wall thickness. Unless I use my internal telescopic spring loaded expanding gauges - and then a micrometer to measure them, I prefer to turn (or find) a close fit and measure that.
Making a plug is always the way I do it, if I am shrink fitting smallish diameters
Making a plug is always the way I do it, if I am shrink fitting smallish diameters