20x16 box section

[BrokenBiker]

does it exist?

ideally i need 20x17, so i can put a 12mm hole in one side without touching the side walls on the inside of the box.

i have some 20x20 here that i can cut and shut if i have to but would rather use an original piece if i could

 

[dan.taylor.1]

Two bits of 20*15 angle welded inside each other giving you 20*17 if it's 2mm thick?

Dan

 

[BrokenBiker]

Two bits of 20*15 angle welded inside each other giving you 20*17 if it's 2mm thick?

Dan

that is going to be my last resort, if i cant find anything suitable i am going to cut down the middle.of some 20x20 with a 3mm disc than weld it back together as 20x17. If that fails then i will have to use angle iron

 

[dan.taylor.1]

Is there no way to modify the design to use 20*20?

Dan

 

[BrokenBiker]

no, the slot it needs yo fit into cant be changed.

i have however come up with a solution. As the slot isn't very deep i cut one side of the box section off and hammered the sides down so they are narrower at the bottom. Fits perfectly