richardhutcheson
New Member
- Messages
- 2
Hi, I've done some welding before but in a garage where i suspect the power was more than 16 amp blue socket.
I'm looking at cutting the rear out of an old fiesta, brace it with 75x50x5mm box section with some custom plates (5mm again) to accept the new rear hubs etc.
Before i start and make a hash, does anyone know if i should be looking at doing this gas or gasless and if indeed a 130 mig welder plugged into a 16amp socket will actually penetrate deep enough.
Not looking a long runs particularly at this stage.
Thanks, i did a search and found some bits but not enough to fill me with confidence to start without checking.
Rich
I'm looking at cutting the rear out of an old fiesta, brace it with 75x50x5mm box section with some custom plates (5mm again) to accept the new rear hubs etc.
Before i start and make a hash, does anyone know if i should be looking at doing this gas or gasless and if indeed a 130 mig welder plugged into a 16amp socket will actually penetrate deep enough.
Not looking a long runs particularly at this stage.
Thanks, i did a search and found some bits but not enough to fill me with confidence to start without checking.
Rich