Shedendman
Member
- Messages
- 5,211
I've spotted a welder on evilbay which looks rather old,as you can see from the specs on the back,its saying,(from what i can make out),that it can go as low as 1amp at 20v on mma and 10v on tig(please correct me if i'm wrong).
Being a dumb dumb here can you weld anything at 1 amp(esp at mma),i've seen a lot of the new-ish type of inverters and the lowest i know of for tig mode esp is 5amp minimum.
That duty cycle,does that look reasonable?
Being a dumb dumb here can you weld anything at 1 amp(esp at mma),i've seen a lot of the new-ish type of inverters and the lowest i know of for tig mode esp is 5amp minimum.
That duty cycle,does that look reasonable?