shenion
Tool Pack Rat
- Messages
- 7,586
- Location
- Stone Mountain, GA USA
Been using 0.030/0.035 wire since day one. Picked up a small roll of 0.024 wire.
It seems much more sensitive to torch stickout length. I don't notice this with larger wire. I was wondering if other notice the same thing?
Was able to get the Miller dialed down to 18A with 0.030 wire. Could even go less but get close to the point wire does not arc, but just turns red and coils up
Amp gauge (0-300A) barely moves 
Still have tweaking on this Miller to do. As it was a spray-transfer only beast, will take a while to get my mods tuned in for light work.
It seems much more sensitive to torch stickout length. I don't notice this with larger wire. I was wondering if other notice the same thing?
Was able to get the Miller dialed down to 18A with 0.030 wire. Could even go less but get close to the point wire does not arc, but just turns red and coils up


Still have tweaking on this Miller to do. As it was a spray-transfer only beast, will take a while to get my mods tuned in for light work.