Might be worth talking to David Ashcroft at Ashcroft transmissions in Luton, have made a few halfshafts for land rover axles in their time.
https://ashcroft-transmissions.co.uk/
I used to sell/ repair/ modify electric fencers years ago Hotline and Gallagher 2 manufacturers that spring to mind. they would take dcv from a battery, use that to charge a capacitor, then once that had reached saturation voltage, discharge through a transformer, repeat. No timer needed, by...
As someone who designs trailers for a living www.stevevick.com and supplies to the utility industry, where nothing remotely dodgy is allowed in the front door (although we all know what happens in reality!), I have to work with the regs quite a bit.
Since the law change requiring type approval...
I have repaired those exact model 3 rotor Countax deck, 38 or 42 IBS s plenty of times now, not too bad if you take a big picture approach.
1 Cut out the centre section that houses all the shafts etc, this preserves all the belt and blade spacing and cover mounting.
2 Cut from 16g or 1.5mm...
Hi Baloo, just a couple of thoughts to ponder, once your mowing deck is hung out the front, is that going to create a bit of a seasaw/ high axle loading/heavy steering over the front axle, as virtually all your engine/transmission weight is over that too?
and have you considered using a ZF s42...
If you are going to use steel tube, then check out hydraulic tube, it can be bought in the length you are after, is really good on tolerance and you can get gland fittings that will fit tightly into the tube and chrome rod to act as an axle. Steerforth or somebody similar have catalogues to get...
Bostik 2402, a 2 pack contact adhesive, used to build neoprene inflatable boats for decades, bonds to most things inc wood, steel and grp so long as you prep the surface properly, ideally with Toluene. Can be separated using hot air gun once cured if you need to peel apart.
cummins pump is 110 bar, pretty sure lr pump will be 85 bar, the cummins pump has a constant flow valve in it and some also have a prv as well which is the bit you need to change the spring in, but I'de just connect it to your steering box and worry about the pressure later, you might find that...
I design and make trailers for the utility industry etc, having seen some outrageous repairs to such devices over the years i would suggest a couple of things if you are set to go ahead with this. Lowering by this amount will really reduce not only your c/g and loading height, which is good...
Ive bought 350+ of their 2050 cylinders and bq 70 air over hydraulic pumps over the last year, failure rate has been pretty low considering they are used in a trench full of mud!
Have got the same printer here, and an ultimaker 2, both really handy. have made some speedo drive gears for people using the formlab printer and their newish carbon fibre material,
seem to hold up ok in the front wheel of a dirt bike.
i tend to use inventor as well, but am slowly getting to...
Bit of resurrection here, but just a bit of info to help, I designed a twin peristaltic pump for mixing polyurethane resin for an industrial foam filling and things to consider are, external housing needs to be very rigid as the pressure requirement goes up, shaft bearings need to be seriously...