Last time i used it it was fine then i switched it back on just to trim something else but the air had dropped right off the torch initially arc ed up then died so im wondering if the lak of air caused the problem. Thanks for your input
Hi is anyone able to help please
My R Tec Plasma cutter has stopped working it turns on but fan and torch do not work.
I have removeed the covers and inside on the top is 2 fuses fully soldered into the board these have both blown so i presume this is my problem..
Does anybody know what the...
I mixed up a small amount of citric acid and water then added the wall paper paste to thicken it . i just kept adding the wallpaper paste flakes and mixing till i got the thickness i wanted but it didnt take loads. it goes a long way so start with a small amount of acid and water to see what you...
ive used citric acid powder with pound land wallpaper paste with no probs at all it mixed into a nice thick Gel yes a bit lumpy but that wud be the cheap paste. sorry but didnt take much notice of quantitys.
i keept cleaning it off scrub with stiff brush and re apply then cover with cling film...
yes as above its consistant and ok when new but when re used it needs the crap paint ect siving out of it you must do this or you will get nowhere never put it in the pot without
As above you must seive your media thats rule number 1 in blasting in my book.. dont try to save time on this job it has to be done especially when using such small nozzles.
looking at the link That blast pot you have should work fine and it shud work fine with your 14cfm compressor all be it a bit short of air ie taking a bit long to do the job but it shud be capable of doing the blastwork ok i know this because this is pretty much my set up . and i have been...
Fixed Fixed Fixed :doh: AHEM just belt trouble im very surprised i thought it was motor related :doh: starts fine and fills in about 4 miniutes now and also restarts fine as the pressure drops phew. its having a good propper service now inc oil as it is overdue :vsad:
Big Thanks to you...
yes will change oil / check belt i dont think any air is leaking but will check . now its out in the open it going to have a good going over . i have been looking up the capaciters as mentioned earlier . will check them also (after unloading them first )
Thanks for the help so far
will change the oil belt tension seems fine. i dont think belt is slipping the motor is going slow (sounds like its going to stall till the pump gets hot) as if its not powerfull enough.
yes it is worse in the winter i do understand this from last winter but it struggled to start all summer i...
something i did notice the pully from the motor got hot after running for 1 to 2 miniutes which i thought was strange the pump pully was cold as you would expect
Any Ideas please
iIhave a clarke air industrial 14cfm compressor .
i have to decompress it to start it the motor seems to be struggling to turn it over untill its hot so its turning over slowly therefore not making the air quickly today it would not keep up with my die grinder.
so pulled it...
Hi can someone please give me a product code for the Lechler Epoxy primer you are all using so i know i am buying the correct iso free product. i rang up express paints last friday and they said it contains iso . i questioned them on it and they said they would speak to the paint rep and ring me...