Hi Folks,
I have a small project on to build some small rabbit runs for the local sanctuary (yes, I was surprised to learn of the existence of rabbit sanctuaries too!).
I have to build a frame (I can email plans, upload complains about size!) from 30mm box section (2.5mm wall thickness I think).
My initial prototype worked a treat other than the long length across the base (circa 6') has bowed upwards.
Should I be making two separate squares (A and B on the plans) and then welding them together with the two pieces in the middle or would my original idea of one long piece across the bottom (C on the plans) hold?
I have a small project on to build some small rabbit runs for the local sanctuary (yes, I was surprised to learn of the existence of rabbit sanctuaries too!).
I have to build a frame (I can email plans, upload complains about size!) from 30mm box section (2.5mm wall thickness I think).
My initial prototype worked a treat other than the long length across the base (circa 6') has bowed upwards.
Should I be making two separate squares (A and B on the plans) and then welding them together with the two pieces in the middle or would my original idea of one long piece across the bottom (C on the plans) hold?