Hi,
While busy melting tungstens out in the shop I was wondering about all the other settings on my welder...
I'm running 90A on 3mm steel, 1.6 tungsten and filler, & cup and 7 lpm argon.
So what should I be using in pre and post current?
What frequency and balance would be best?
I've read the guide on here but couldn't find a mention of all these extra settings?
I realise there's no substitute for torch time but hopefully starting off with some good setup on the machine would make it a bit easier?
Cheers
While busy melting tungstens out in the shop I was wondering about all the other settings on my welder...
I'm running 90A on 3mm steel, 1.6 tungsten and filler, & cup and 7 lpm argon.
So what should I be using in pre and post current?
What frequency and balance would be best?
I've read the guide on here but couldn't find a mention of all these extra settings?
I realise there's no substitute for torch time but hopefully starting off with some good setup on the machine would make it a bit easier?
Cheers