Brad93
Member
- Messages
- 17,574
- Location
- Essex, United Kingdom
I need to make a dxf for a profilers to get something cut from hardox.
I need to draw a 4000mm long x 150mm wide piece of 25mm thick hardox flat bar and then put 10 half length slots to form the basis of a set of grizzly bars for a feeder. 15mm hardox flat bars will slot into these slots. Slots should be 16mm wide i suppose.
Now the problem is i don't know the exact dimensions so want to use parameters to be able to alter the drawing at a later date without too much legwork but i don't know how to do it.
I also need to make the pattern on 400mm centres all the way down the bar. Again i need to be able to alter the centres.
any advice.
I need to draw a 4000mm long x 150mm wide piece of 25mm thick hardox flat bar and then put 10 half length slots to form the basis of a set of grizzly bars for a feeder. 15mm hardox flat bars will slot into these slots. Slots should be 16mm wide i suppose.
Now the problem is i don't know the exact dimensions so want to use parameters to be able to alter the drawing at a later date without too much legwork but i don't know how to do it.
I also need to make the pattern on 400mm centres all the way down the bar. Again i need to be able to alter the centres.
any advice.