What are you guys using for stud extraction, Looking at extractors and they seem less than adequate for prolonged use.
Any other recommended stud extraction methods ?
Nothing specific just need to tool up for future work.
Yer that's ok for the ones where there's a length sticking out although i gave up holding one nut with a spanner and tightening the other with my teeth so i use 2 nuts & 2 spanners....
What about broken off flush or below the surface is what i should of been clearer on
Weld a nut on to it is my first option
Drill it then use a fluted easy out or hammer a torx bit in (about the best use for them)
The left hand drill approach often brings easy ones straight out