The microcontroller, RF receiver and buzzer are now on a perf board. I'm not the best at soldering but it works so I'm happy. I've never soldered a perf board before. It's difficult to make it neat! Thankfully most of the connections and soldering is on the bottom of the board so you can't see it .
I'm currently using the usb to power the microcontroller however note the black and yellow wires that appear near where I have the usb plugged in. These will be used for power once it's fitted in the car.
Next stage is to design and 3d print a case for this board.
I'm currently using the usb to power the microcontroller however note the black and yellow wires that appear near where I have the usb plugged in. These will be used for power once it's fitted in the car.
Next stage is to design and 3d print a case for this board.