Onoff
In the land of the unfinished project I am King!
- Messages
- 12,428
- Location
- Sevenoaks, UK
I've two Verniers, a digital, no name one and a Mauser, manual one.
The "blades" on both aren't thin enough to go into a 1mm circlip groove I've cut.
Any particular (ideally cheap) tool I can buy that'll get in there and measure this?
Cheers
The "blades" on both aren't thin enough to go into a 1mm circlip groove I've cut.
Any particular (ideally cheap) tool I can buy that'll get in there and measure this?
Cheers