brokenbiker
Member
- Messages
- 10,437
- Location
- Llanbobyll, south wales
following on from my 'gas lense' thread, the lad i know that wanted more consumable rang me in work today to ask an electrical question about the above welder.
he said he has been playing in 2t and 4t with the torch switch only so far, but decided to plug the pedal in, so set it to 2t, set the other switch to pedal and set the current to about 150ish...
pressed his foot down on the pedal and nothing...not even a tiny flash. took the plug out, put it back in, checked setting etc but it just wont work. i asked about earth lead and he assured me it was fine and on shiney metal (direct tot he plate he wanted to weld)
i have no idea what the inside of this welder looks like but he wants me to pull it open and check the wiring.
does anyone know the pin outs for this welder and its pedal? i would assume the wiring wont be too complicated, possibly only 2 wires but would like to know either way so i know what to expect when i open it up
he said he has been playing in 2t and 4t with the torch switch only so far, but decided to plug the pedal in, so set it to 2t, set the other switch to pedal and set the current to about 150ish...
pressed his foot down on the pedal and nothing...not even a tiny flash. took the plug out, put it back in, checked setting etc but it just wont work. i asked about earth lead and he assured me it was fine and on shiney metal (direct tot he plate he wanted to weld)
i have no idea what the inside of this welder looks like but he wants me to pull it open and check the wiring.
does anyone know the pin outs for this welder and its pedal? i would assume the wiring wont be too complicated, possibly only 2 wires but would like to know either way so i know what to expect when i open it up