Problem with this welder, the wire feed isn't working, all was running fine last time I used it, now theres no action from the feed motor.
The fuse on the board is ok, theres continuity thru the trigger switch and what looks to be an overheat thermistor on the transformer, .
So I flicked the cover off the relay/contactor on the board and made the contact and it works.
So any ideas guys or do I need a new board., If it needs a new board where do I get one?
Supaimpy aka Keith
The fuse on the board is ok, theres continuity thru the trigger switch and what looks to be an overheat thermistor on the transformer, .
So I flicked the cover off the relay/contactor on the board and made the contact and it works.
So any ideas guys or do I need a new board., If it needs a new board where do I get one?
Supaimpy aka Keith
Last edited by a moderator: