anto44
Member
- Messages
- 1,832
- Location
- ireland
Thought I'd put up this thread for some of the general stuff I do.
Todays job was to modify an oil pick up pipe for an Audi.
I cut about 1 inch out of it
Cleaned the ends off on the belt grinder so the fit up was nice and tight with no gaps and deburred the inside with a carbide bit.
That light over the bench is one of the best things I've gotten. Saves straining the eyes trying to see scribe lines etc.
Todays job was to modify an oil pick up pipe for an Audi.
I cut about 1 inch out of it
Cleaned the ends off on the belt grinder so the fit up was nice and tight with no gaps and deburred the inside with a carbide bit.
That light over the bench is one of the best things I've gotten. Saves straining the eyes trying to see scribe lines etc.