Hi all,
Have a bit of a dilemma, after reading about what mig to buy ,i decided to go for a "clarke 160TM. But 1st i phoned Clarke's sale's who said that i could Not use the above machine on a 13amp supply! But i could if the supply was 1 phase. The supply to my Garage is 16amp were the mig would be used.
Is this ok or would i need to put in a new or extra mains supply? In the weldequip shop it says 13amp 230v. Tried to phone them but engaged.
Any advice whould be appreciated. Till then on hold .
Thank's Kevin
Have a bit of a dilemma, after reading about what mig to buy ,i decided to go for a "clarke 160TM. But 1st i phoned Clarke's sale's who said that i could Not use the above machine on a 13amp supply! But i could if the supply was 1 phase. The supply to my Garage is 16amp were the mig would be used.
Is this ok or would i need to put in a new or extra mains supply? In the weldequip shop it says 13amp 230v. Tried to phone them but engaged.
Any advice whould be appreciated. Till then on hold .
Thank's Kevin