Hi to everybody here.
I have the telwin mig 180-2 and i am trying to convert it to euro tortch. I bought allready MB25 and an adaptor for this.
The new tortch has two wires, the same as the old one, i connect them and the wire feed works fine. These are the two white on the top. The two red and black located in the lower bottom are going to the wire feed motor (it is 24VDC).
The problem is the gas. The old tortch had a mechanical valve, but the MB25 hasn’t.
I know i need a gas solenoid. But:
1.What voltage
2.Where to connect the 2 wires of the gas solenoid, to works with the trigger of the euro tortch together with the wire feed ?
Thanks for any answer.
I have the telwin mig 180-2 and i am trying to convert it to euro tortch. I bought allready MB25 and an adaptor for this.
The new tortch has two wires, the same as the old one, i connect them and the wire feed works fine. These are the two white on the top. The two red and black located in the lower bottom are going to the wire feed motor (it is 24VDC).
The problem is the gas. The old tortch had a mechanical valve, but the MB25 hasn’t.
I know i need a gas solenoid. But:
1.What voltage
2.Where to connect the 2 wires of the gas solenoid, to works with the trigger of the euro tortch together with the wire feed ?
Thanks for any answer.