Kram
Member
- Messages
- 6,232
- Location
- Sussex
Yes that is the plan I am going to mill the tube face flat and from the OD of the tube to the back corner, so somewhere around 60 degrees I imagine. It would have been much simpler if I started with 30mm thick plate and bored a hole to weld in a 50mm bar as the upright.Could you when removing theb outer edges actually make is so th cutting bit comes out of a triangle point to give you a bigger max working range Will it have an extension handle fitted ? What range of radius will the balls be <
Range it has enough clearance and should be able to do 100mm concave to 60mm diameter balls.