Hi,
I welded a 10mm thick flange over an aluminum manifold and even if I clamped it to the table, I still got it 1mm warped in the middle.
I'd like to reduce the warp as much as possible before grind it:
would pressing it in the middle and heat it work?
Any advice?
Thanks
I welded a 10mm thick flange over an aluminum manifold and even if I clamped it to the table, I still got it 1mm warped in the middle.
I'd like to reduce the warp as much as possible before grind it:
would pressing it in the middle and heat it work?
Any advice?
Thanks