Hi,
A real newbie question about stick out. I am not sure if I had this or even if it is a problem, but when I cut the stick out to normal length I notice that I have to get rid of around 10 to 15 mm of essentially loose or extra wire that freely comes out if I gently pull. The wire then firms up again until the next time I trim. For the life of me I can’t think if it has always done this, if it is normal or I have problem to sort out. I am using 0.8 solid wire through a MB25 torch.
Any thoughts or suggestions welcome.
A real newbie question about stick out. I am not sure if I had this or even if it is a problem, but when I cut the stick out to normal length I notice that I have to get rid of around 10 to 15 mm of essentially loose or extra wire that freely comes out if I gently pull. The wire then firms up again until the next time I trim. For the life of me I can’t think if it has always done this, if it is normal or I have problem to sort out. I am using 0.8 solid wire through a MB25 torch.
Any thoughts or suggestions welcome.