Richard.
Member
- Messages
- 18,347
- Location
- Cambridgeshire
Wow that’s very different to what I was getting.
Perhaps it’s just different ages and characteristics of the sets. The one I did it on was a brand new 500 amp inverter
I think your about right with 12mtrs a min. I wouldn’t worry about volts and amps Matt. If your machine is putting out 12mtr min then just dial in that voltage till you get a nice spray condition. It should be almost silent with a little crackle occasionally.
I was using argon shield heavy with a quality 1mm wire. Is your set up similar
Perhaps it’s just different ages and characteristics of the sets. The one I did it on was a brand new 500 amp inverter
I think your about right with 12mtrs a min. I wouldn’t worry about volts and amps Matt. If your machine is putting out 12mtr min then just dial in that voltage till you get a nice spray condition. It should be almost silent with a little crackle occasionally.
I was using argon shield heavy with a quality 1mm wire. Is your set up similar