johnburke
New Member
- Messages
- 10
- Location
- Dublin, Ireland
Following on from another thread about a fault with my Sip migmate T194, which ended in the unit being beyond economic repair. This leaves me in need of a new mig welder.
So my choices, after much research!, are an SIP 180 auto plus or a Deca mig 420s, both are single phase, very similar in spec with good duty cycle figures so it's hard to decide on which.
Any input, experience, thoughts or opinions welcome about either makes or models. I don't mind spending money I just like to make sure it's well spent
So my choices, after much research!, are an SIP 180 auto plus or a Deca mig 420s, both are single phase, very similar in spec with good duty cycle figures so it's hard to decide on which.
Any input, experience, thoughts or opinions welcome about either makes or models. I don't mind spending money I just like to make sure it's well spent