just after some advice on my migmate 100 I’ve had for years. It’s just stopped working after being used for about an hour. The machine shows power on the switch but the wire feed is not working. It won’t strike an arc on the wire either.
I’ve taken the pcb out of the unit MIG03IPF. I noticed the relay contacts looked dirty so I took the cover off. With the unit switched on I can manually activate the relay by hand and the wire feed starts working and the unit will strike an arc. It seems whatever is supplying power to the coil in the relay isn’t working.
Does anyone have any idea what it might be? Is there a cutout switch somewhere I could check? Is it the pcb? If it’s the pcb where can I get a replacement or old one repaired?
Cheers for your help
I’ve taken the pcb out of the unit MIG03IPF. I noticed the relay contacts looked dirty so I took the cover off. With the unit switched on I can manually activate the relay by hand and the wire feed starts working and the unit will strike an arc. It seems whatever is supplying power to the coil in the relay isn’t working.
Does anyone have any idea what it might be? Is there a cutout switch somewhere I could check? Is it the pcb? If it’s the pcb where can I get a replacement or old one repaired?
Cheers for your help