thinfourth
pleb
- Messages
- 1,189
- Location
- Stonehaven
Due to having a wee bit too much time on my hands due to a lack of job I have decided to make Mk2 of my ring roller.
mk1 was basically spitted balled together with whatever junk i had to hand and it has served me very well allowing me to bend all manners of flat bar.
Mk2 has the following aims
Be a wee bit more accurate and repeatable then mk1
Have a larger capacity then mk1
Built out of some stuff i have laying around
Let me get a handle on fusion 360
So step 1 is to draw it up in Fusion 360
Jack screw yet to be added
mk1 was basically spitted balled together with whatever junk i had to hand and it has served me very well allowing me to bend all manners of flat bar.
Mk2 has the following aims
Be a wee bit more accurate and repeatable then mk1
Have a larger capacity then mk1
Built out of some stuff i have laying around
Let me get a handle on fusion 360
So step 1 is to draw it up in Fusion 360
Jack screw yet to be added