pc18
Member
- Messages
- 128
Hi guys. this is the exhaust manifold i got on my rwd kp60 starlet
space is quite limited!
flat spots in the runners
nice flange
collector
not sure whats going on here
So what do you guys think, should i cut out the crap bits on this one and re make it. or should i just start again?
the engine has had quite alot of work done to it and i want to squeeze as much as i can out of it. plus something that looks a bit nice under the bonnet would be nice.
i was thinking a nice stainless one would be nice and give me some good practise with my tig. better to practise making something instead of jsut wasting consumables i think.
oh and a quick one of the car
space is quite limited!
flat spots in the runners
nice flange
collector
not sure whats going on here
So what do you guys think, should i cut out the crap bits on this one and re make it. or should i just start again?
the engine has had quite alot of work done to it and i want to squeeze as much as i can out of it. plus something that looks a bit nice under the bonnet would be nice.
i was thinking a nice stainless one would be nice and give me some good practise with my tig. better to practise making something instead of jsut wasting consumables i think.
oh and a quick one of the car