ajlelectronics
Forum Supporter
- Messages
- 8,626
- Location
- Gloucester, England
I need to replace my lost spanner that I use on Weber carburettor nuts. The access is not easy and there isn't much clearance between the nut flats and the carburettor wall. I don't recall the brand I had but it was highly polished, not that it matters.
I have found the PROXXON 13MM SPANNER 23913 but not much else that declares being thin wall. I was also hoping not to pay that much, torque is 1Lb/ft so it's not going to break.
I have found the PROXXON 13MM SPANNER 23913 but not much else that declares being thin wall. I was also hoping not to pay that much, torque is 1Lb/ft so it's not going to break.