SBK
Member
- Messages
- 458
Hi all
I recently convinced myself that I need a Plasma cutter
I bought a shop soiled unit from R Tech a P30-c.
It is having a hard time cutting clean through 2 mm alli and 4 mm steel .
The display just reads 003 all the time no matter what power setting I have it on.
Spoke to Dylan At r tech and he reckons its water in the air supply,so drained the tank not much in it anyway and always drain it at the end of each day.
They sent me a new torch but its still the same see Pics.
Am i doing somthing wrong with it or am i just expecting too much from the machine ??
cheers
I recently convinced myself that I need a Plasma cutter
I bought a shop soiled unit from R Tech a P30-c.
It is having a hard time cutting clean through 2 mm alli and 4 mm steel .
The display just reads 003 all the time no matter what power setting I have it on.
Spoke to Dylan At r tech and he reckons its water in the air supply,so drained the tank not much in it anyway and always drain it at the end of each day.
They sent me a new torch but its still the same see Pics.
Am i doing somthing wrong with it or am i just expecting too much from the machine ??
cheers