Hello, I have welding my mk1 golf for about a year, almost finished but could do with some advice about my 'butt' join of the rear valence.
Basically, I can't do seam but welds. I end up blowing holes or distorting the panel. For the rear valence, I made lots of little spot welds until I had a continuous seam. However, on the other side of the panel, the seam is not so continuous and there are some small gaps between welds. What would you do?
1. leave it alone an fill
2. fill in the gaps from the inside with lots of little spot welds.
i have tried to add pictues.
Basically, I can't do seam but welds. I end up blowing holes or distorting the panel. For the rear valence, I made lots of little spot welds until I had a continuous seam. However, on the other side of the panel, the seam is not so continuous and there are some small gaps between welds. What would you do?
1. leave it alone an fill
2. fill in the gaps from the inside with lots of little spot welds.
i have tried to add pictues.