Simon Culmer
New Member
- Messages
- 1
- Location
- Harpenden
Just went to use my Migatronic 5000MX today and the wire feed stopped working. No feed at all when the trigger was pulled but a slight amount of feed when released, this eventually gave out too though. Welding circuit is fine however.
I put a voltmeter across the feed motor wiring and there is nothing there so likely the fault is before the motor. Anything else I can try (limited electrical skills) or can anyone recommend a Migatronic repair shop in Herts/Beds?
I put a voltmeter across the feed motor wiring and there is nothing there so likely the fault is before the motor. Anything else I can try (limited electrical skills) or can anyone recommend a Migatronic repair shop in Herts/Beds?