Hi, my son and i are about to start a little project .I have a SIP migmate 130 turbo,just after some advice .
Planning giving welder a bit of a service before we start ,so was planning changing the liner . So which would you Steel or plastic ?
The project is a off road buggy ,so not sure which wire to go for 0.6mm/0.8 ?,i normally use 0.6 mm but the bulk of my work was wrought iron si it was fine for that ,will using 0.8mm make the mig run hotter ?
I live up here in the highlands so my choice of Argon gas supplier is very limited ,idealy i'd like to get a half normal size bottle what kinda money will i have to fork out ?
Ta for looking
Sean
Planning giving welder a bit of a service before we start ,so was planning changing the liner . So which would you Steel or plastic ?
The project is a off road buggy ,so not sure which wire to go for 0.6mm/0.8 ?,i normally use 0.6 mm but the bulk of my work was wrought iron si it was fine for that ,will using 0.8mm make the mig run hotter ?
I live up here in the highlands so my choice of Argon gas supplier is very limited ,idealy i'd like to get a half normal size bottle what kinda money will i have to fork out ?
Ta for looking
Sean