northwest
Searching for the Holy Grail.........
- Messages
- 5,401
- Location
- Manchester UK
I have an idea about making a drill bit. Very long story short, I occasionally regularly get barrels in with a couple of bullets lodged in them, I can only see this problem (of how to get them out) getting worse with the advent of Non Lead i.e. brass bullets. So what I propose is to make a long drill using Silver Steel and using bushes on the drill shaft to keep the bit central. If I can get a hole down the middle it usually relieves the pressure enough to just push them out. I am looking for ideas and a design for the drill bit end, I thought maybe a 'D' bit, but will this want to wander by design?
Any and all designs/ideas/suggestions welcomed. It is a bit of "deep hole drilling" without the drilling because it is only the one bit I need to get at. The bit that is blocked.
Any and all designs/ideas/suggestions welcomed. It is a bit of "deep hole drilling" without the drilling because it is only the one bit I need to get at. The bit that is blocked.