mart
Member
- Messages
- 1,899
- Location
- South Yorks
I was removing the armature from my 2450 Makita drill having received the new parts. As I pulled the original armature out of the casing, the bearing in the photo must have snagged on the pins from the mode selectors inside the casing.
It is jammed in the position shown here. I have thought about gently tapping it with a small tack hammer but I don't want small ball bearings coming out
. So far, I have only tried to gently prise the position of the baring with a screw driver, but 'gently' is not working.
What are my options for sorting this?
It is jammed in the position shown here. I have thought about gently tapping it with a small tack hammer but I don't want small ball bearings coming out
What are my options for sorting this?
Last edited: