I have some parts i have made from 4mm steel tube (as it was the only tube i could find that had the correct ID)
I find the parts are pretty heavy for the application, So im thinking about putting some holes around the tube to lighten it.
The tube is 76mm OD with 4mm Wall. 205mm Long. Ideally looking to put 4 holes in the tube, 2 at the front, 2 on the back. Around 50mm in diameter.
Thoughts?
I find the parts are pretty heavy for the application, So im thinking about putting some holes around the tube to lighten it.
The tube is 76mm OD with 4mm Wall. 205mm Long. Ideally looking to put 4 holes in the tube, 2 at the front, 2 on the back. Around 50mm in diameter.
Thoughts?