Paul G
Member
- Messages
- 932
I came across a job lot (3) of tube benders and was going to sell 2 and keep 1.
So the question is;
Can a former be made to fit a Hilmor CM42 that will successfully bend 25mm box to say a 125mm rad?
Anyone done it ?
If so, did it deform much ?
I know that these benders are made mainly for copper but these are big bu**ers made for up to 42mm.
Cheers,
Paul G
So the question is;
Can a former be made to fit a Hilmor CM42 that will successfully bend 25mm box to say a 125mm rad?
Anyone done it ?
If so, did it deform much ?
I know that these benders are made mainly for copper but these are big bu**ers made for up to 42mm.
Cheers,
Paul G