grahew
New Member
- Messages
- 7
- Location
- pershore
Hi can anybody offer me some advice, I have a six month old 60amp plasma cutter and am having problems as follows the air is set to 60-75 psi and even at full load 50amp plus the cut is poor I have a twin set up on air so it is well filtered from moisture the max thickness of mild steel plate being cut is 6mm. I have cleaned the metal to a shine! for a good earth but still the cut is poor leaving holes and poor ragged edges and finally I have tried different heights for the tip but to no avail!
help its driving me crackers!!!!!!!!!!!!!!!!
help its driving me crackers!!!!!!!!!!!!!!!!